3D PRINTED PIECES | raspberry-pi-system

3d Printed Pieces for the Raspberry Pi Emulator

Front Panel

This is the front of the Raspberry Pi Emulator. You can see the holes for the buttons as well as the joystick. The big space in the middle is for the screen. The circles at the bottom are for the speakers.

Back Panel

This is the back of the Raspberry Pi Emulator. The hole in the middle is for the battery pack. The boards will be screwed into this in order to hold them in place. Those are the small holes you see.

Battery Cover

This is where the battery will be held in the back of the system. It will be held in place by the piece below.

Battery Cover Holder

This will hold the battery cover with the batteries in place.

Button

This is the button. There will be two of them on the top of the system.